Home & DIY calculators

Deck board calculator

How many deck boards, joists and screws you need, based on your deck size, board width, gap and the board lengths you can buy.

Deck boards29 boards
Rows of boards26
Linear feet (no waste)416 ft
Joists (about)13
Deck screwsabout 676
Deck area192 ft²

How it works

Rows = deck width ÷ (board width + gap), rounded up. Boards = rows × lengths per row, plus waste. Joists are counted along the deck length at your spacing, plus one at the end, and screws are two per board at every joist.

Nominal boardActual widthRows per 10 ft of deck (1/8 in gap)
2×4 / 5/4×43.5 in34
2×6 / 5/4×65.5 in22
Composite (typical)about 5.5 in22

Tips

  • Buy boards at least as long as the deck where you can. Joins (butt joints) must land on a joist, and stagger them across rows.
  • Add 10% extra for straight layouts and 15% for diagonal or picture-frame borders.
  • This calculator covers the decking surface only. Beam, post and footing sizes depend on spans and local code, so check with your building department.

Pouring footings? Use the concrete calculator. Need the area of an odd-shaped deck? Use the square footage calculator.

FAQ

How many deck boards do I need for a 12×16 deck?

With 5.5 in wide boards (standard 5/4×6 or 2×6) and a 1/8 in gap, a 12 ft wide deck needs 26 rows. Using 16 ft boards that is 26 boards, or about 29 with 10% extra.

What is the actual width of a 6 inch deck board?

Most 6 in nominal deck boards, both 5/4×6 and 2×6, are 5.5 in wide. 4 in nominal boards are 3.5 in. Composite boards are usually about 5.5 in, but check the brand.

How far apart should deck joists be?

16 in on center for most wood and composite decking laid straight. Many composite brands require 12 in for diagonal layouts, and 24 in is only allowed with thicker boards. Follow your board maker’s instructions and local code.

How many screws do I need per deck board?

Two screws at every joist the board crosses. That works out to roughly 350 screws per 100 sq ft with 5.5 in boards on 16 in joists.

What gap should I leave between deck boards?

About 1/8 in for kiln-dried wood, close to none for wet pressure-treated lumber (it shrinks as it dries), and 3/16 in or the maker’s spacing for composite.

Advertisement